Overview / Responsibilities :
The Engineer - Process shall have familiarity with steady state and dynamic process simulation using ASPEN HYSYS/ UNISIM/ PetroSIM or equivalent process simulation software. Know-how and independently contribute to small to medium size projects with minimum supervision from senior staff, discipline leads, or project managers.
The Engineer-process shall:
Independently perform work scope assignments with minimum guidance from senior staff.
Assist in the preparation of project documents and ensure quality and project compliance.
Continuously learn and enhance capabilities in either focused technical areas (through deeper understanding) or broad technology areas via diversity of experience.
Support other work as may be required on a time-to-time basis. This may involve, specialty studies, development work, production of guidelines or other similar work.
The Engineer-II shall ensure that they comply with the Company HSE Policy and Quality Management System (QMS). It should be noted that each person has a responsibility for the safety and quality aspects of the work that they undertake. Any questions or concerns relating to HSE and/or the QMS should be brought to the attention of the Project Manager.
Good technical understanding of process simulation (both steady state and dynamic simulations) for oil and gas industry.
Good technical understanding of compressor systems (including anti-surge control logics, compressor surge analysis using dynamic simulations), different failure modes and their impact analysis during plant operation. Good understanding on API codes, oil and gas industry design guidelines.
Hands on experience on developing dynamic simulation model of centrifugal compressors implementing the associated equipment inertia parameters, anti-surge controller details for performing compressor coast down surge analysis. To perform compressor dynamic analysis for block discharge scenarios, compressor trips, adequacy of Anti-Surge control valve etc.
Hands on experience in developing offshore production platform HYSYS Dynamic study including the equipment’s (Liquid & gas handling facilities) associated controllers, compressor systems, etc based on the P&ID and in line with Cause & Effect Matrix.
Verify adequacy of PSVs, flare capacity during ESD scenarios.
Ability to understand the process based on information available in P&IDs, PFDs, operating and control philosophy, shutdown philosophy to execute the project effectively.
Ability to extract required process parameters from relevant process deliverables like H&MB, equipment and instrument datasheet, P&ID, PFD for developing steady state or dynamic simulation.
Skills / Qualifications
B.E/B/Tech/M.E/M/Tech in Chemical Engineering with minimum CGPA 7.0 or 70% marks.
Min 6 years’ experience in the field of developing Dynamic process simulations.
Well versed with ASPEN HYSYS/ UNISIM/ PetroSIM or equivalent process simulation software, Knowledge on FLARENET analysis, PIPENET software for pressure surge analysis will be an advantage. Should poses basic understanding of startup/shutdown procedures for units like compressors, pumps, separators.
Operation experience will be an added advantage in addition to dynamic model building skills.
Candidate should have good presentation & report writing skills.
Exposure to pipeline simulations using PIPESIM / OLGA / SPS is an advantage.
Good soft skills.
